NASTRUCK
SECTION B
1.0 BODY
1.1 Approved Nastruck 200mm bodies 1/10 bodies scale only.
1.1a Approved bodies are HPI ( Ford, Chevy, Dodge, Toyota), McAllister (Ford, Chevy, Dodge, Toyota), Proline Protoform ORT
1.2 Any paint scheme can be used. Truck Must have numbers on sides and top
1.3 Numbers controlled by Race Director
1.4 Round air flow cutouts in windshield are allowed with a max. dia. of 2”.
1.4a Air flow cut-outs in windshield in shapes other than round are allowed, but with a max. of any size of 2”. measured in any (including diagonal) direction.
1.4b Cut-outs for motor and breather are also allowed.
1.5 No other cut-outs allowed
1.6 Body must be trimmed along factory’s trim lines around bottom of the body.
1.7 Spoiler must be on truck centered with two sided tape, glued or bolted.
1.8 Spoiler can be attached to deck lid on back or top.
1.9 Spoiler blade width to be 1 ½” max.. Top of spoiler blade to be 1 ½” max. from top of deck lid.
1.10 Side dams to be no more than ¾” wide and no higher than the height of the spoiler.
1.11 Spilers 7” long max. and centered on deck.
1.12 Deck lid max. height 3 ¾” (top of deck lid to ground)
NOTE: Track body template available for inspections.
2.0 TRUCK & CHASSIS
2.1 Stock, RTR 1/10 Associated NTC3 touring car chassis only
2.2 Truck must weigh Min 64oz. (4 pounds, 1816 grams) according to official track scales.
2.3 Any size fuel tank is allowed.
3.0 ENGINE & EXHAUST
3.1 Approved .Engine protest fee is $25.00 (See rules A5.0 for protest and procedure)
3.2 Approved .12 size engines are as follow:
3.2a Stock O.S. .12CV with O.S. 10E rotary carb; Duratrax and O.S. 12CVR replacement heads are allowed for this engine only.
3.2c Stock Dynamite .12 SPD with stock rotary carb. And stock head.
3.3 Approved engine modifications. An engine will still be considered “stock” with the following modification.
3.3a An engine’s crank may be cut as required for the attachment of a clutch nut.
3.3b An engine’s pull start may be removed.
3.3c The pull start catch-pin on the crank may be removed by grinding or cutting.
3.3d A non-pull start back plate may be added
3.3e An engine’s head may be replaced as allowed by section 3.2a.
3.3f An engine’s piston and sleeve may be replaced with piston and sleeve that matches stock specifications.
3.4 Any other modifications made, including but not limited to, polishing, cutting, grinding, or otherwise altering a stock engine, will make the engine considered illegal.
3.5 No restrictions on Air Breather
3.6 RTR exhaust system (RPM muffler OK)
4.0 TIRES
4.1 Approved rubber tires only. Approved tire manufacturers are:
4.1a Take-Off
RP
Team Much More (“Sweep” brand)
Team Orion
BSR Touring mounted CAP Tires
5.0 TRANSMISSIONS
5.1 Single speed only